We are fundamentally dependant on oil in most of the developed world. Pulse engine technology is the solution to that dependance. The great thing is that it works on any piston engine including your current vehicle. It Uses AIR and there are NO POLLUTANTS

This is the ultimate green Technology

Wanna Know More?
The Idea came from recognising that we need to fundamentally change the worlds addiction to oil without removing the benefits of the machinery it powers. So the criteria was No fuel and must be able to be reversally fitted to all existing vehicles cheaply.

And I found a way

Years of trying all sorts of methods with eletromagnets and coils and alternatives like separating water I finally just looked at what we are doing with a piston in a cylinder and it struck me July 4 2008. I was making it all too complex.

The pulse method works by compressing AIR to the same pressure as an exploding fuel mixture and releasing it into the cylinder at just after TDC.

Yes its that Simple

I know its a fair amount of pressure but steel is a very strong material and we only need a cylinder full at that High pressure to be delivered to the combustion chamber at the correct time.

We are talking a closed system so it is just moving the air from High to low presssure areas explosively to drive the piston up and down.

More Pressure More acceleration.

There are some distinct advantages to not wasting so much energy as heat, one is you dont have to deal with the heat and the second is that much more energy can be concentrated on doing the job that we need, driving that piston up and down.

Store the Compressed air in a tank and use half the engine as a compressor using valves and blocking intake and exhaust manifolds, while the other half provides the power. Or use one stroke for power and another to compress. And top up pressure from a compressor running off the engine like an Air conditioner compressor when looking for acceleration.

And for larger applications I propose we use microwave generated steam to create the necessary pressure to push a full load. Basically the same system just have a microwave chamber on the high pressure side to create the very high pressure needed. Basically using a little water to create the steam pressure that can be collected and recycled internally.

If for some reason you want to go back to Fuel just remove the components and put the spark plugs back in and Fire it up.

To start the car just run the starter motor until it comes to idle pressure then it will run. Give it a couple of minutes at idle and you will have operating pressure.

Then off you go

Remember Half the engine is acting as a compressor so when the engine is running you replace all the compressed air you are using no matter what speed the engine is running at. The tank is only used to maintain pressure

I wonder if the fuel companies have known this for years and have just not said anything to maintain the fake economy of oil

What a wonderful world

Adam